(D) Vortex Flow Meter plug-in installation steps: 
 1. Pipe welding in the open with a little less than φ100mm of the hole, and cleaned the burr around the hole to ensure the probe rotation fluent 
 2. Hole in the pipe at the weld on the flange provided by the manufacturer, required pipe flange axis and the vertical axis. 
 3. The ball valve and sensors installed in the welded flange on. 
 4. Adjustment screw, so that the insertion depth to meet the requirements (to ensure that the central axis of the probe and the pipe central axis coincide), the fluid flow direction must be marked with the arrow indicating consistent. 
 5. Evenly tighten the gland cover screws. (Note: the tightness of gland sealing of the instrument and determine whether the rotating screw) 
 6. Check whether the completion of all aspects of good, and slowly open the valve to observe whether there is leakage (with special attention to personal safety) Repeat steps 5 and 6 if leaking. 
 Sales Hotline: 15236456068 
 0373-2678877