High temperature (+80 degrees to +500 degrees), Normal temperature (-30 degrees to +70 degrees), low temperature (-40 to -200 degrees) meter installation: 
 a, normal temperature, low temperature, high temperature flow meters depending on the conditions used horizontally, vertically or upside-down installation (subject to a single factory calibration); 
 b, medium temperature at +300 degrees, the user is responsible for meter housing insulation to prevent heat radiation to damage the header (header operating temperature of -30 to +70 degrees), working temperature -100 degrees empathy media, but also to take freezing measures; 
 c, in order to ensure accurate flow measurement, the requirements in straight pipe before and after; (Figure 8) 
 d, in order to ensure the meter inspection and replacement work does not affect the system should try to set the bypass valve (3) and cut-off valve (1,2); (Figure 8) 
 e, due process requires can be mounted vertically, the bottom can be measured medium flows, but also from top to bottom, but the description of the supplier should be ordered; 
 f, flow meter connected to the pipe diameter and the same diameter size as much as possible to reduce the flow disturbance caused by measurement error; 
 g, flange and clamp-on flowmeter installation, attention should be between the flange gasket bore size is greater than the flow and process pipe diameter 6-8mm and not coaxial, to avoid its interference flow affect the measurement accuracy; 
 h, plug-flow meter installation, the short tube and flange welded to the pipe must ensure that the fluid film force facing the target surface, the short tube weld height 100mm (from the pipe wall to the flange sealing surface distance) ; (Figure 9) 
 i, the completion process for the new pipeline should be installed after the initial purge flow meter; 
 j, measure the tube wall of the measured direction of the arrow for the media flow;